System information

221 02-FGB 101 544 Uen A – September 2008 29
The duration of the DTMF-tones sent from the Ericsson W35 towards the
network is determined by the TE and the network settings and are not
configurable in the Ericsson W35.
6.2.6 On/Off-hook Timeouts
These settings determine the time needed for the Ericsson W35 to consider
the phone to be on- or off-hook.
6.2.7 Hook Flash Time
This setting controls the “Hook Flash” feature which on most modern
phones is implemented as a button that simulates a quick off-hook/on-
hook/off-hook cycle. This is the same function as quickly tapping at the
hook on an old style phone, also called Register Recall (the R-button).
The setting specifies the time-window in which the on-hook condition exists
in order to be interpreted as a hook flash.
6.2.8 CLIP
The Ericsson W35 supports CLIP (Calling Line Identification Presentation)
service in both on-hook and off-hook states using the DTMF and FSK
protocols, supporting both ETSI and Bellcore standards.
It is possible to configure a country specific profile for the CLIP service.
An international prefix for the CLIP service is also configurable. This setting
determines how a “+” character should be displayed (e.g. 00).
6.2.9 On Hold Ring
This setting specifies what will happen if the user goes on-hook with an
active call placed on-hold. If enabled, the user will be notified about a
remaining on-hold call ring signal. If disabled, all calls will be disconnected
when going on-hook.
6.2.10 Tones and Signals Profile
The tones and signals profile includes local settings for ringing signals and
information tones generated by the Ericsson W35 (in opposite to the tones
received from the network).
Tones and signals profiles for the following countries are currently
supported:
• Austria (AT)
• Australia (AU)
• Spain (ES)
• Hungary (HU)
• New Zealand (NZ)
• Sweden (SE)
• United Kingdom (UK)
• United States (US).
These settings might be overridden by the operator network.