Ericsson W20 Fixed Wir eless T erminal for WCDMA/HSDP A Wireless Terminal WCDMA/HSDPA Mobile Networks Quick Installation Guide
No part of this document may be reproduced in any form without permission from the copyright owner owner.. The contents of this document are subject to revision without notice due to continued ess in methodology pr ogr methodology,, progr ogress design, and manufacturing. Ericsson shall have no liability for any error or damage of any kind resulting from the use of this document. © Ericsson Enterprise AB 2006 All rights reserved. LZT 108 8745 R1 Table of Contents INTRODUCTION ...........................
INTRODUCTION This Quick Installation Guide provides instructions on how to install and get started with your Ericsson W20 Fixed Wireless Terminal. For further information about the product, advanced configuration, and troubleshooting, see the User’s Guide included on the enclosed CD. For information about connection of services, please contact your service provider. NOTE! Carefully read the document containing safety and regulatory information included on the enclosed CD.
INST ALLA TION INSTALLA ALLATION The installation procedure is divided into three steps: 1. Preparation of the Ericsson W20, where necessary physical connections are made. 2. Basic configuration, where the mobile network and wireless LAN connections are configured. 3. Identification of a suitable location and wall mounting the unit. Be sure to follow these steps as described on the following pages to successfully install the Ericsson W20. 1 - UNIT PREP ARA TION PREPARA ARATION 1 .
3. Connect power Connect the cable from the enclosed power supply adapter to the 10-28 VDC power input on the Ericsson W20. Connect the power cord to the power supply adapter and then insert the plug into a mains outlet. 4 . Connect a PC 1-4 Attach the enclosed Ethernet cable to one of the LAN (1-4 1-4) connectors on the Ericsson W20 and connect the other end to the Ethernet connector on a PC.
The “User login” page is displayed: Type user in both the “User name” and “Password” text fields and click the Login button. The “Overview” page is displayed: 2 . Run the Configuration Wizard The Configuration Wizard can be used for easy setup of the mobile network and wireless LAN connections. To start the wizard, click Configuration Wizar Wizard d and then follow the onscreen instructions to complete the wizard.
3 - CHOOSING A LOCA TION LOCATION The Ericsson W20 has primarily been designed to be wall mounted. Always select an indoor location, preferably close to a window and the ceiling which generally will give the best conditions for both the mobile network and wireless LAN. For best results, place the Ericsson W20 away from microwave ovens and other transmitters (e.g. security/alarm systems) as they can cause signal interference.
HARDWARE DESCRIPTION CONNECTORS The connectors on the Ericsson W20 are positioned as shown in the illustration below. A description of each connector is provided in the table below (from left to right): Label Description 10-28 VDC Power input for connecting the included power supply adapter. Reset Reset button used to restore the Ericsson W20 to its factory default settings.
INDICA TORS INDICATORS The front panel of the Ericsson W20 has five (5) status indicators. A general description of each indicator is provided in the table below (from top to bottom): Te x t S t a t u s Description Power Green Unlit Power is on. Power is off. Mobile Network Green Yellow Flashing Unlit UMTS network is available. GSM network is available. Searching for a connection. No connection to the mobile network. Internet Green Unlit Connection to Internet established. No Internet connection.
© Ericsson Enterprise AB 2006 LZT 108 8745 R1
