Operating instructions

Home > SPR1100 Handbook > Installing the Equipment > Mounting in a Rack > Cable Types/Installing Cables

Cable Types/Installing Cables

Cable Types

The signal cable types (or similar) described in the following table are those recommended

by Ericsson in order to maintain product EMC compliance.

Signal Type

Connector

Cable

Ethernet (Control)

RJ-45

Alcatel Data Cable FTP 7 x 0.16

Ethernet (Data)

RJ-45 Cat 5e

Belden Datatwist (S-FTP)

Installing Cables – Safely

Power supply cables should be routed so that they are not likely to be walked on or pinched

by items placed upon or against them. Pay particular attention to cables at plugs,

convenience receptacles, and the point where they exit from the appliance.

Do not run AC power cables in the same duct as signal leads.

Do not move or install equipment whilst it is still attached to the mains supply.

Ensure safety and ESD precautions are observed whilst inter-connecting equipment.