Operating instructions

Home > SPR1100 Handbook > Appendices > Option Cards > Handling Option Cards > Removing an Option Card

Removing an Option Card

WARNING!

Refer to "HANDLING OPTION CARDS" to minimise risk of damage to option cards or base

chasis.

An option card can be removed, and does not need to be replaced.

Disconnect any cables from the option card to be replaced.1.

Loosen the two captive screws that retain the option card in the base chassis.2.

Holding the captive screws, pull the option card from the unit and place it in suitable

anti-static packaging, (observe the handling precautions).

Fit a blanking panel in place of the removed option card.4.

When the unit detects a card is no longer present, it will be displayed on the option

slots web page, and an alarm will be raised. If all options are reported correctly, the

“accept option slot configuration” needs to be applied. This will accept the new

hardware configuration and clear the alarm.