Specifications

Appendix
RX8200 Configuration Guide
iv
Figure 40. Configuring Multicast MAC Address and PID
Within the MPE section, make sure the following information is included:
 PID: – From the drop down tab, the PID 3550 – USER should be available once the receiver is tuned into
RLS. If not then it will appear after the User PID has been selected and the changes applied to the
receivers configuration.
 Filter MAC: - Enter the MAC address as shown in Multicast Address graphic above for your region.
 User PID: - 3550
 MPE Enable: - Select this box.
 Also ensure that the MPE Enable tick box is enabled for IP Out Link 2 and then click Apply Changes to
store this configuration.
To change the IP Output 2 address select the Output tab. As this network Interface directly connects to the WNE
Server the IP address convention used globally is 172.16.2.2.
Ensure the Tx Enable tab remains deselected. A tick mark should not be displayed in the Tx Enable box as shown
in the graphic below.