Specifications

Appendix
RX8200 Configuration Guide
iii
Configure the satellite input parameters for the client site. Please use the Global Satellite Coverage options in this
document to determine the local settings required for your client region. Ask a client engineering representative for
the frequency details of the LNB connected to their in-house satellite dish.
Figure 38. L-band Input 1 Configuration
When all the configuration parameters have been entered click on the Apply Changes tab to ensure the settings
are saved. The receiver should now be tuned into the RLS service and the Front Panel LED of the RX8200 should
have changed to an Orange colour. This will also be reflected on the home Status page of the receiver. If at this
point, you are not able to lock to a new satellite signal, ensure you have the appropriate features enabled as
outlined in Appendix 7.
For WNE, two multicast IP addresses exist to distinguish between PAL/625 and NTSC/525 on Reuters WNE (i.e.),
each broadcast stream exists on a separate multicast address.
These addresses are provided below:
Standard
IP Address
MAC Address
Hexadecimal
525/HD60
224.14.14.14
01:00:5E:0E:0E:0E
625/HD50
224.14.14.15
01:00:5E:0E:0E:0F
Figure 39. Multicast Addresses on WNE
To configure the transmission standard specific to your region, navigate to the Decode tab of the RX receiver
browser page.