Specifications

Appendix
RX8200 Configuration Guide
ii
APPENDIX 2 MANUAL CONFIGURATION
Manual Configuration of the RX8200 to lock to RLS and WNE. The screen shot examples below show a different
default management IP address. Please ensure you are using a 172.16.2.20 IP address for Control 2 management
interface.
Please also note that the following screen shots may not be identical to the RX8200 unit to hand as different
firmware versions of the unit have additional menu options.
Configuration of the RLS Service paramaters must be configured first.. Select the Input tab on the RX8200
browser interface
Figure 36. Satellite Input
Select the Satellite Input tab at the bottom of the browser page.You will now see a list of the L-band inputs. The RF
signal from the satellite dish should be connected to Input 1 as shown in section 2.2 of this document.
Figure 37. Satellite Input Screen