User guide

Operating the Equipment Locally
Reference Guide: RX1290 H.264 Contribution Receiver Page 3-11
ST.RE.E10228.1
Table 3.11: Manually Selecting the Audio Components
Step Action Result
1 Go to the Menu 3.2 and press Edit. Select
one of the audio streams or enter an audio
PID.
Selects the audio component.
2 Scroll to Menu 3.2.3 and edit the Audio 1
delay adjustment (range ± 0 to 49.5ms).
Press Save.
Edits the Audio 1 delay adjustment.
3 Scroll to Menu 3.2.4 and edit the Audio 1
digital output format (AES3 or AC-3) and
output routing (STEREO, MIXED TO BOTH,
LEFT TO BOTH, or RIGHT TO BOTH).
Press Save.
Edits the Audio 1 digital output format and output routing.
Note that when the input signal is STEREO, the Audio digital
output format will always be STEREO.
4 Scroll to Menu 3.2.5 and edit the clipping
value (12 – 24 dB). Press Save.
Edits the clipping value.
5 Scroll to Menu 3.2.6 and edit the
AC-3 down mix parameter (SURROUND
STEREO or CONVENTIONAL STEREO)
Press Save.
Edits the AC-3 down mix parameter.
6 Go to the Menu 3.3 for Audio 2, Menu 3.4
for Audio 3, Menu 3.5 for Audio 4 and
repeat steps 2 through 5.
Selects the audio component.
3.7.4 Setting Up Asynchronous Data (RS-232)
These menu pages allow status monitoring and configuration of the low speed data.
Table 3.12: Setting Up Async Data
Step Action Result
1 Go to Menu 3.6 and press Edit. Select the
data stream PID.
Selects the data stream.
2 Scroll to Menu 3.6.1 and edit the
low speed data output (ENABLED or
DISABLED). Press Save.
The unit receives and displays the correct bit-rate.
3.7.5 Setting Up High-speed Data Over Ethernet
These menu pages allow status monitoring and configuration of the high-speed data over
Ethernet software option.
Table 3.13: Setting Up High-speed Data over Ethernet
Step Action Result
1 Go to Menu 3.7 and press Edit. Select the
data stream PID.
Selects the data user PID number.
2 Scroll to Menu 3.7.1 and edit the
High-speed data output (ENABLED or
DISABLED). Press Save.
The unit receives and displays the correct bit-rate.
3 Scroll to Menu 3.7.3 and edit the Forward to
Gateway ON/OFF and the Gateway IP
address menu. Press Save.
If the Forward to Gateway option is turned on, the unit will forward
the data stream to the gateway address given.