Specifications

1. Move switches S2 and S3 to the "run" position
(toward the back of the GETC shelf).
2. Press S4 to reset the GETC.
3. The Turbo Board LEDs, D1 and D2, will light
indicating the station code is executing.
4. Disconnect the TQ-3360 programming cable upon
successful completion of the programming
procedure.
For additional information on programming the Turbo
Board, refer to the Turbo Board Maintenance Manual LBI-
38822 and Software Release Note SRN-1062.
CONFIGURATION
The configuration process involves the following
operations:
1. Personality Programming - Use this procedure to
set up the CNI GETC Personality.
2. Repeater Personality - Describes the procedure for
setting up the MASTR III or IIe Repeater
Personality (not required for MASTR II).
3. Dip Switch Settings - Provides instructions for
setting DIP switches for CNI operation.
4. Modem Alignment - Provides Instructions for
adjusting phone line levels.
5. CEC/IMC Personality Configuration - Describes
the procedures necessary for setting up the System
Manager and CEC/IMC for Conventional Network
and Group ID’s.
PERSONALITY PROGRAMMING
Personality refers to the system configuration data
stored in the GETC’s memory. The GETC’s Personality
includes system configuration information such as channel
frequencies, call parameters, operating modes, and
identification information.
The Personality Programming process stores the
Personality data in EEPROM U35 on the GETC Logic
Board (CNI GETC’s with EPROM 344A3497G1). This
process involves using the TQ-3357 (Version 3.00 or later)
GETC Shelf PC programming Guide which includes the
programming software.
Programming Set-up
Prepare the PC for Personality Programming by
performing the following steps:
1. Connect the TQ-3360 programming cable from the
PC’s serial port connector (COM1/COM2) to the
CNI GETC Shelf connector J100 (see Figure 10).
(A DB-25 to DB-9 adapter may be needed.)
2. Set the GETC DIP switches S1, S2, and S3 for the
programming mode as shown in Figure 9.
Programming the Personality
Program the personality into the CNI using the
following procedures:
1. Reset the GETC by either cycling power or
pressing the GETC RESET switch S4, located just
below the DIP switches. Resetting the GETC, in
combination with the DIP switch settings, places
the GETC into the Personality Programming mode.
2. Verify that front panel LEDs L3, L4, and L5 are
ON, this indicates the GETC is ready for
programming.
This software is subject to change resulting from
improvements or enhancements. The instructions
contained in this manual are for guidance only. When
programming the personality, the detailed instructions
contained in TQ-3357 and the accompanying software
takes precedence over this manual.
NOTE
Figure 9 - Switch Settings for Personality Programming
Mode
LBI-38986
15