FDC FIXED DOCKING CRADLE WITH DATA-PORT INSTALLATION AND OPERATING INSTRUCTIONS Page 1
FDC Fixed Docking Cradle with Data Port: The FDC serves the function of converting a mobile phone to have the capabilities of a fixed phone. The Ericsson R190 mobile satellite phone when docked onto the cradle will become a fixed phone unit. In addition, the cradle has an in-built charger, which will charge the docked R190 and a speaker, which will give the R190 hands free functions. In other words, a speakerphone feature allows the R190 user to talk without lifting the handset to the ear.
(g) (h) (i) (j) (f) (k) Figure B – Front Panel of FDC Refer to the front of the panel; the following are the features (from left to right) as: f) Telephone handset The handset, when resting on the cradle, allows the speakerphone to become operational. Otherwise, by lifting the handset, the user can talk privately. g) Cavity for docking R190 The cavity on the center is for docking the R190. The base of the R190 should be inserted into the wire connection at the bottom of the cavity.
Labels / Symbols found at the back panel: Data Port = A data port connection Data Call = Flip the switch to either Voice / Data Call according to your use DC 12V = A power supply connection = Antenna connection Where ‘ ‘ = ON charging switch and ‘ ‘ = OFF charging switch Charge Switch Satellite Orbital Slot Orbital Type Launch Date Frequency Network Dimension (mm) Weight (g) Colour Power Source Line Interface Environment Type Dimension (mm) Weight (g) Impedance Connector SPECIFICATION SYSTEM Garuda-1
INSTALLING THE HARDWARE (1) Connecting the Antenna Cable to the FDC a. Connect one end of the antenna cable (SMA type connector) to the connector marked “ “ on the back panel of the cradle. Refer to Figure A. b. Turn the connection clockwise and tighten very well. (2) Connecting the Telephone Handset to FDC a. Connect the coiled-cable end of the handset to the front side of the panel as shown in Figure A. b. Make sure that the connector is firmly plugged in place.
TROUBLESHOOTING Problem Action The Power Supply Indicator Light Does Not Come 1. Check if the Power Supply Push Button is On pressed down. 2. Check if the Power Adapter is connected to the power supply. 3. Check if the Cradle is connected to the Power Adapter. Unable To Register With The Network 1. Check if the Antenna Cable is properly connected to the Antenna. 2. Check if the Antenna is directed to the satellite.
