Specifications

PROGRAMMING INSTRUCTION
The UHF synthesized mobile radio is equipped with a personality EEPROM. All customer information such as the
customer frequencies, customer tones and customer options are stored in the EEPROM. The EEPROM contains all
information to tailor the operation of the radio to the user’s requirements. The EEPROM is programmed by using an
IBM compatible personal computer with MSDOS, Programming Cable TQ-3376 and Programming software
TQ-3375.
PROGRAMMING THE RADIO
The Programming Cable TQ-3376 is a Y-cable. The base of the "Y" has a standard 25 pin connector which plugs
into the computer, the remaining end has a 6 pin connector which fits into the connector PL1 on the digital board
inside the radio. To use this cable, remove the top cover of the radio as described in the DISASSEMBLY section.
Plug the six pin connector into the socket inside the radio (PL1), which is located near the EEPROM IC107. Plug the
base of the "Y" into the computer that will program the radio. See the diagram in TQ-3375 Software Manual. In
order to program the radio with the programming cable, it is necessary to put the radio into the programming mode.
To do this, press the P "PRIORITY" button/LED on the radio and turn the radio ON. The radio will sound a prompt
tone and show the words "PROG" on the display. Please refer to the Software Manual for further instructions on the
operation of the Programming Software. After completing the programming instructions in the Manual, remove the
cable from PL1 and replace the cover on your UHF synthesized mobile radio.
MONOGRAM SERIES LBI-38865
PROGRAMMING INSTRUCTION
Page-17-
Nov. 94