Specifications
INSTALLATION LBI-39000B
77
7.4.2. Verification Test at the CEC/IMC Manager
At the CEC/IMC Manager:
Log in to the CEC/IMC Manager.
Select View System/Diagnostics.
At the System Display, check to ensure that "P" is not blinking.
At the Site Display (use function keys to switch between displays), check to ensure that the Jessica site number is not
blinking.
At the Link Status Display (F9), check for "LU," which stands for Link Up.
7.4.3. Verification Test at the PI
At the PI:
Ensure that the power is on.
Log in at the terminal.
At the pSOS prompt (pSH+>), check the system status by typing "Status".
Verify the following:
ISDN Comm Status has Comm Enabled and No Trunk Alarms.
IMC Comm Status has Comm Enabled and Link Up.
Total Channels has the proper number of channels.
7.4.4. Jessica Installation Verification
This section provides information on how to verify that Jessica is functioning properly.
The following tests are performed for clear voice and digital voice unless the system does not support both. Consult your
radio user’s manual for instructions on making the calls below. If any calls fail, consult section 8 for information on
troubleshooting.
Table 10 - Installation Verification
Test Results
Make an inbound individual call from an
MD110 extension.
Hear ringing at the phone followed by audio after the radio is
answered. The call will terminate when the radio clears it or
when the phone hangs up, provided line clearing from the
telephone reaches the PI.
Make an inbound single-site group call from
an MD110 extension.
Hear ringing at the phone followed by audio after the radio is
answered. The call will terminate when the phone hangs up,
provided line clearing from the telephone reaches the PI.
Make an inbound multisite group call from an
MD110 extension.
Hear ringing at the phone followed by audio after the radio is
answered. The call will terminate when the phone hangs up,
provided line clearing from the telephone reaches the PI.
Make an outbound call to an MD110
extension.
Hear queue tone at the radio, then ringing followed by audio
when the telephone is answered. The call will terminate
when the radio clears it or when the phone hangs up,
provided line clearing from the telephone reaches the PI.