User`s guide

MBR L13 – User’s Guide
82
Encoder Volume
HSS Interface Input Gain /
Decoder Volume
These parameters adjust the input (Rx) volume.
Tone generator Volume
This parameter adjusts the volumes of all progressive telephony
tones that are used in PBX calls: Busy tone, dial tone, call
progress tone, etc.
 To activate the call-waiting audio notification for analog extension (administrator only):
Under Call Waiting, select Enable ACK Spoofing for Caller ID Call Waiting.
Figure 110 Call Waiting table
Note: Time From the End of CAS to the Start of Data is a technical parameter that should only be set by authorized
technical-support staff.
 To Change the FXS Ports Settings (administrator only)
The FXS Ports section contains advanced electronic settings for the FXS (analog) port, which should only be modified
by an experienced administrator or technician.
Figure 111: Advanced – FXS Ports
The following settings can be modified:
Parameter
Description
Select country
Select the pre-defined FXS /POTS line configuration from
the list of countries which responds to your region.