User`s guide

MBR L13 – User’s Guide
50
1. Click the NAT link of the Firewall menu item under the Services tab. The NAT screen appears.
2. Click the New IP Address link in the NAT IP Addresses Pool section. The Edit Item screen appears (see Figure
64: Edit Item).
3. Select the IP address option and enter 192.168.71.12.
Figure 64: Edit Item
4. Click OK to save the settings.
5. Click the New IP Address link again to add an additional Public IP to NAT IP Addresses Pool. This sequence is
for demonstration purposes; you may enter your public IP addresses in the method that suits you.
6. Select the IP range option and enter 192.168.71.13 through 192.168.71.20.
Figure 65: Edit Item
7. Click OK to save the settings. The new IP addresses are displayed in the NAT IP Addresses Pool section.
Figure 66: NAT IP Addresses
8. Click OK to save the settings.
You can now add NAT/NAPT rules based on these IP addresses.
 To add a NAT/NAPT rule:
1. Click the New Entry link in the NAT/NAPT Rule Sets section. The Add NAT/NAPT Rule screen appears.