User`s guide

MBR L13 User’s Guide
28
Configure the fields as follows:
Parameter
More Info
Enable WiFi
Check or uncheck this box to enable or disable the WiFi connection
WiFi Network (SSID)
The L13 supports a single SSID. The system arrives with a default
preconfigured SSID that may be manually changed in this field.
Note: The SSID is case sensitive.
SSID Broadcast
By default, the SSID is broadcast so that all wireless client devices within
range of it can detect it. You can choose to hide the SSID. If you do so, only
client devices that know the SSID will be able to connect to L13, and the SSID
will have to be entered manually on each device in order for it to connect.
Clear this option to turn off broadcasting of the SSID.
802.11 Mode
Select the type of connection. Choose from B-G-MODE, G-MODE-ONLY, B-G-
N-MODE, G-N-MODE, N-MODE-ONLY
Channel
A specific wireless channel, over which the system will operate, can be
chosen. It may also be set up automatically.
Channel Width Mode
This option appears on platforms supporting 802.11n only. At this point
make sure you always work in "20 MHz only".
Network Authentication
Only the 'Open System Authentication' option is available in this version.
MAC Filtering Mode
To enable MAC address filtering, select either “Allow” or “Deny”.
If you select “Allow,” only devices whose MAC addresses appear in the MAC
Filtering Table (defined in the next section) are allowed to connect to the
Wi-Fi network. If you select “Deny,” devices whose MAC addresses appear in
the MAC Filtering Table are not allowed to connect to the Wi-Fi network (all
other devices are allowed to connect).
3.6.2.3 MAC Filtering Settings
The MAC Filtering Table contains a list of MAC addresses for filtering. The filtering rule is defined above, under “MAC
Filtering Mode”.
Figure 26: MAC Filtering Table
To define filtering for a MAC address:
1. Click 'New MAC Address'. The 'MAC Filtering Settings' screen appears.