User guide

Advanced Configuration
1553-ZAT 759 94 Uen A – October 2004
33
4.4.2.1 Firewall Settings
The Firewall is by default disabled meaning that the configuration is set to
allow all PCs on your network to contact all Internet web sites. You can
configure HM410dp to block access to certain Internet Websites from some
or all the PCs on your network.
From the Advanced Setup menu, click on Security. The “Security State”
part displays information about the security settings.
To change the state of the Firewall select Enabled and click the Change
State button.
Note: To save the Firewall state permanently, you MUST perform a Save
Config. From the left hand menu, select Advanced Setup > Save
Config and then click the Save button.
A new part named “Firewall Configuration” is now displayed on the Security
page. Click on the link Configure Port Filters to create a port filter: