User guide

Initial Configuration
1553-ZAT 759 94 Uen A – October 2004
13
Password provided by your ISP. Once you have entered your Username
and Password within this Wizard, the HM410dp will automatically connect
to your ISP whenever you use your Internet connection.
The HM410dp automatically activates the NAT service and its internal
DHCP server. PCs on the LAN will be assigned private IP addresses from
the built-in DHCP server and the NAT service will route the traffic to/from
the WAN.
Note: If you already have PPPoE client software installed on your
computer(s), you must uninstall it. This can be done after
completing this wizard.
To configure the HM410dp for PPPoE Routed access type, follow the steps
below:
1 From the Start page, click the Configuration Wizard > button to display
the following page:
2 Select PPPoE routed and click the Next> button. The following page
appears:
3 Enter your ”Username” and ”Password” provided by your ISP and click
the Next> button. The Confirm page for Internet access appears: