User guide

Initial Configuration
1553-ZAT 759 94 Uen A – October 2004
9
3 Initial Configuration
This chapter describes how to access the built-in Configuration tool and run
the Configuration Wizard in order to perform the initial configuration.
3.1 Introduction
The HM410dp is an advanced ADSL router with several features and
supported modes that make it ideal for advanced home networking. The
HM410dp offers a Configuration Wizard that enables you to easily
configure the HM410dp through a user friendly GUI. No special software is
required on your PC to manage and operate the HM410dp. All you need is
a web browser.
In the Configuration Wizard you can select an Internet Access type that fits
your needs. There are currently three pre-defined access types as shown in
the table below where they are briefly described.
Table 3 Description of Internet Access Types
Connection Type Select Internet Access Type
Connect using DHCP or fixed IP
address (without a Username and
Password).
Some operators provide Username
and Password also for this type of
connection, but the login procedure
is in this case done from a web
page or similar.
DHCP Routed (MER)
Bridged
Connect using PPPoE (sometimes
called dial-up). This type of
connection requires a Username
and a Password.
PPPoE Routed
The HM410dp still offers the possibility for advanced users to set up special
network scenarios themselves or to modify the existing ones. Refer to
chapter 4 – “Advanced Configuration” for further information.