User guide

Hardware Description and Installation
6 1553-ZAT 759 94 Uen A – October 2004
2.3 Placement of the HM410dp
The HM410dp can be placed either in a horizontal or upright position on a
flat surface (i.e. a table) as shown in the figures below:
Note: Proper ventilation is necessary to prevent the product from over-
heating. Do not block or cover the slots and openings on the
device, which are intended for ventilation and proper operation.
Figure 3 - Alternative Placement for the HM410dp
If you choose to place the HM410dp in an upright position, use the provided
table stand and fit the 4 pins on the table stand into the holes on the bottom
of the unit:
Figure 4 - Mounting of the Table Stand