User guide

Important information
78 (87) EN/LZT1083982 R4
2000-12-07
Note:
The HM220d ADSL high speed modem is for use only with
AC/DC Adapter Ericsson Model BML 901 92/2 and
minimum AWG 26 cable required for telecommunications
connection.
Note:
In the event of equipment malfunction, replace only with
AC/DC Adapter Ericsson Model BML 901 92/2.
9.3.4.1 Declaration of Conformity
9.3.4.1.1 FCC Part 15
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC rules (Code of Federal Regulations Title 47,
Telecommunications (CFR 47)). These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with these instruction, may cause harmful
interference to radio or television reception. However, there is no guarantee that
interference will occur in a particular installation. If this equipment does cause harmful
interference to radio or television, which can be determined by turning the equipment off
and on, the user is encouraged to eliminate the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna of the affected equipment.
• Increase the separation between the HM220d ADSL modem and the affected
equipment.
• Connect the HM220d ADSL modem power supply to an outlet on a circuit different
from that to which the affected equipment is connected.
• Consult your service provider or an experienced radio/TV technician for help.