User guide

Configuring the modem
EN/LZT1083982 R4 57 (87)
2000-12-07
Finishing the modem setup
Figur 55: Configuration wizard - Finishing the modem setup
This is the last page in the wizard and it includes all your settings. Review the list and:
• click the Back button to make any changes to previous pages
• click the Finish button to confirm all settings
• click the Cancel button to close the Configuration Wizard without saving any
settings.
When you have accepted the settings (by clicking the Finish button) the parameters will
be set and a check is performed that their values are correct.
Note:
This will take a while, but just wait until the "Status
message" appears.
If anything is incorrect you will be notified by the following status message: "The
parameters could not be altered according to your changes. Check the settings and consult
the documentation for help".
In that case, use the Back button to return to previous pages and make the necessary
changes.
When your settings have been accepted the following status message is shown (picture on
next page): "The parameters have been set. Press 'Reboot' to reboot the modem".