User guide

If the PIN is correct, you will hear a beep over the

telephone (positive indication tone). If it is incorrect,

a deep tone will sound (error indication tone).

If the PIN is entered incorrectly three times, the SIM

card will be blocked. If this happens, you can

unblock it by using the PUK (Personal Unblocking

Key), which you also get from your network operator.

See SIM Card Security on page 33.

Note: once you have entered the PIN code for the

first time, you will not have to enter it again unless

you change your SIM card. The FCT performs this

operation automatically in case of power failure.

Network search

After you have switched on your FCT and entered the

PIN, the FCT automatically searches for a network.

Note: if the red light is off, there is a problem with

the power supply. See “Troubleshooting and FCT

indicators” on page 35.

When a network is found, the green light switches on

or flashes depending on the GSM signal strength. See

“Light Indicators on page” 35.

Note: if the green light is off, you do not have access

to the GSM network at your present location.

Now you have prepared the FCT for wall installation.

Please, follow the instructions below for complete

wall installation.

Installing the FCT on the wall

FCT Location

The GSM signal strength available at the FCT

location affects the performance of the unit. The

stronger the GSM signal, the better the FCT

performance.

ip: test several potential locations by moving the

FCT while looking at the green light . Select the

location where the green light is steady, or the

location with the highest amount of flashes.

Note: moving the FCT as little as 20 cm can affect

the GSM reception quality.

Connections 13