User guide

DT690
6.1.3 Mute ring signal temporarily
If the phone rings at an inconvenient moment:
1. Press
to suppress the ringing.
All a lert signals, including the vibrator, will silence for this specific call.
2. Press
to answer the call.
6.1.4 Switch ring signal off
You can set your phone to silent ringing, when your phone is in idle mode:
• Press and hold
to switch the ring signal on or off. When switched off,
is shown. All alert signals will silence until the ring signal is switched on
again. If the vibrator is set to On when silent, it will alert you of new calls,
messages and alarms. See Section 17.1.3 on page 91.
6.1.5 Reject the call
If you do not want to take the call, when the phone rings:
•Press
to reject the call.
The call is disconnected.
6.1.6 End the call
To end a call:
•Press
.
The display shows the duration of the call. The total time of the call can
also be retrieved from the calls tab.
6.2 Parallel Ringing
The Parallel Ringing function makes it possible for an incoming call to ring
several phones simultaneously and for the call to be answered on any of the
phones. The main advantage of this function is minimizing the risk o f losing
calls. The function requires all the phones involved to be defined in a parallel
ringing list, which must be configured and initiated by your system administrator.
Because only calls to a main extension will be distributed among the phones
in the list, this main extension also needs to be defined. A call to a specific
extension will not be distributed to other phones in the list. Parallel Ringing can
be temporarily disabled by the phone user using the function Internal Follow-me.
For more information on Internal Follow-me, see Section 12.2 on page 65.
34
1424-EN/LZT 103 088 Ue n A2 2008-11-21