User guide

Installation
It is also possible to transfer a call to the Bluetooth headset by pressing the *
button on the Bluetooth headset.
19.8.8 Switching to a headset with cord
If a headset with a cord is connected during a call, the call is automatically
transferred to the headset.
19.8.9 Operation notice
Accessibility and Voice quality
Bluetooth uses the frequency of 2.45 GHz. WLAN, microwave oven, and other
devices that use the same frequency can disturb the use o f a Bluetooth headset.
Operation Area
Maximum distance between the headset and the telephone is 10 metres.
The communication distance between the handset and headset may vary
considerably due to the environment and disturbances from other 2.45 GHz
equipment. Different headsets can also give different communication distances.
Out of Range
If a connection cannot be made with the selected Bluetooth headset the call
is transferred automatically to the telephone. If the Bluetooth headset and
the telephone get out of range from each other the connection is temporarily
lost. Since the last connected headset is always considered "selected", the
connection is automatically established again when a call is made or received.
19.9 Belt Clip
The clip on the back of the ph
one helps you fasten it to a belt or similar.
To attach or remove the cli
p:
Spread the clip slightl
y. The ends of the clip fit into holes on the side of your
phone.
19.9.1 Attaching Hinge-
type Clip
Attach the hinge
clip as described in Figure 19 on page 112.
111
1424-EN/LZT 103 088 Uen A2 2008-11-21