User guide

21Dialog 4422 IP Office
Start the Phone – Log On/Off
Start the phone
Connect the phone to the local network.
See section “Installation” on page 89.
If an external power adapter is used:
Connect the adapter to the mains and connect the plug from
the adapter to “terminal POWER” underneath your phone.
See section “Installation” on page 89.
After a few seconds the Headset key lamp will light for about five
seconds, then the display shows:
The
x indicates a timer counting down seconds. If no key is
pressed during this time, “no change” is selected automatically (if
the procedure is not interrupted by a key press).
Notes:
The administrator mode is used to change the IP settings in
your phone. This mode is reserved for your system
administrator.
If you want to use the previously stored setting, you can
speed up the procedure by pressing the Speaker key.
Now the display informs that the phone is connecting to the server
and software is loading. This takes about 15 seconds. After a self
test, the phone is ready for log on.
Use administrator mode
to change IP settings (x)