User guide

Settings
BusinessPhone – Analog Telephone60
Ringing signal
By programming, you can adjust the ringing character and ringing
volume. To change the ringing character and volume, you have to
enter the programming mode.
Programming the ringing character and volume for the
Dialog 4106 Basic
The ringing signal character can be adjusted with three different
characters, each with another three volume levels.
u Lift the handset.
Wait for the dial tone.
¥ Press.
# Press.
z Enter Digit from the table below.
Notes:
Default setting is digit 6. If you choose 0, the ringing signal
will be turned off until the next time you go off hook.
Please note also that you will not hear the ringing singing
signal during programming.
¥ Press.
The selected ringing signal is stored.
d Replace the handset to finish the procedure.
Digit (character)
Ringing character
- Repetition rate Ringing volume
11 timeSoft
2 1 time Medium
31 timeLoud
44 timesSoft
54 timesMedium
6 (default) 4 times Loud
7 10 times Soft
810 timesMedium
9 10 times Loud
0NoneOff