User`s guide

40(59)
Datum/Date Rev
Dokumentnr/DocumentnrUppgjord/Prepared
Dokansv/Godkänd - Doc respons/Approved Kontr/Checked Tillhör/Referens-File/Reference
99-07-15 A
365/155 34-ASB 150 02 Uen
FACILITY DESCRIPTION
Faktaansvarig - Subject responsible
Capacity / Limitations
On telephones with a small display it is not possible to
show the full (8-digit) private network number and the
presently shown textual information. In such cases,
always the text, not the number, is truncated.
The following scenarios apply depending on the type
of the text shown on the display:
a If the text is a calling/called user name, the name
is truncated.
b If the text is a system message to the ASB150 02
user, the message is truncated.
Programming
Prerequisites:
In order to have access to the services of a given
Networking package, a FECU must always be
plugged- in on the CPU-D4.
For more information regarding the Networking
Packages, see
INSTALLATION INSTRUCTION
EXCHANGE CABINET BDV 113 08,
document number 1531-BDV 113 08 Uen,
INSTALLATION INSTRUCTION
EXCHANGE CABINET BDV BS 101 05,
document number 1531-BDV 101 05 Uen
chapter
FEATURE ENABLING CONTROL UNIT (FECU)
and
FACILITY DESCRIPTION - GENERAL,
document number 15534-ASB 150 02 Uen
chapter FUNCTIONALITY OF ASB 150 02 WITH /
WITHOUT CONNECTED FECU.
The following commands are only accessable via
RASC
Q/T Link settings
1910
Basic Access mode
This command is used to specify the type of the Basic
Access connection mode.
At connection to S - interface, user mode is valid.
At connection to T - interface, network mode is valid.
At connection to Q - interface, network mode
(Q-reference point) is valid.