Operation Manual

Not
f
or Comm
e
r
c
ia
l
Use
E
ricsson Mobile
Com
m
unic
a
t
i
ons A
B
94 Extra features
4. Press UP or DOWN to select one of the following options:
•
SingleCell default setting; the base station operates in stand alone mode.
•
MultiCell the base station works together with other base stations to form
a larger coverage area.
5. Press
YES to confirm.
The cell mode is set.
If the base station is connected to a switchboard, you can use its functions in
the same way as with a conventional fixed telephone. The only difference is
the absence of a telephone cable. One example of this type of function is
transferring calls.
Telephoning using a switchboard
When you use a switchboard, it is sometimes necessary to wait for the dial
tone before dialling a number. If the whole number is to be entered and dis-
played prior to dialling, for example a stored number, then you must indicate
where in the number the handset should wait for the dial tone.
To include a pause (to wait for the dial tone) in a number, press
for one sec-
ond. A dash appears in the handset display to show you where you have set the
pause.
If there is a dash in a number, the handset waits a while for the dial tone. If
you hear the dial tone, the handset continues dialling without waiting for the
full dial tone pause period.
Some telephone networks use pulses when dialling a number. If your cordless
phone is set to pulse dialling, you can switch to tone dialling if required, for
example to control a teleservice.
To switch the handset to tone dialling during a call:
Route:
DialMode » GoToDTMF
• Select GoToDTMF and press YES.
The handset now uses tone dialling.
When you hang up, the handset goes back to pulse dialling. The pulse dialling
setting stays when you switch off.
USING A SWITCHBOARD
PULSE OR TONE DIALLING