User manual

Not for commercial use - Ericsson Inc.
Some menus/features are operator dependent.
10
Answering a Call
Press YES to answer the call. When the call is finished,
press
NO to end the call.
Rejecting a Call
Press NO or press either volume key twice when the
phone rings. The display now shows:
A busy tone will be sent to the system. If Call Forward-
ing is activated, the number will transfer to the desig-
nated number (such as voice mail).
If the calls are not forwarded, the caller will hear a busy
tone.
If you have been unable to answer an incoming call, or if
you have rejected a call, the calling line identification
(caller id) of unanswered calls will be shown in the
missed calls list until you press
CLR (this is dependent on
your subscription). Press
YES to view the missed calls list.
Putting a Call on Hold
If you are engaged in a call, you can put it on hold by
pressing
YES. (where is the call identity)
will appear in the display. To retrieve the held call, press
YES again.
To mute the call, press and hold
CLR. Release to resume
conversation. This mutes the microphone so that you
can have a private conversation without the person at the
other end hearing.
About Calling Line Identification (CLI)
The Calling Line Identification service (CLI) shows the
caller’s phone number when you receive a call (you may
have to order this service). If the caller’s name and corre-
sponding number is stored in your phone book, the
name is displayed instead of the number.
Sending Your Phone Number
If your subscription normally hides your number/ID
when calling, you can show the number on a designated
call.
1
Enter the number you wish to call.
2
Press
. The display shows
3
Press
YES to make the call and send your phone num-
ber.
Hiding Your Phone Number
If your subscription normally sends your number when
calling, you can hide your number on a designated call.
1
Enter the number you wish to call.
2
Press
twice. The display shows Hide Id?
3
Press
YES to make the call and hide your phone num-
ber.