User`s manual

LBI-39117
13
❏
TDM Slot Configuration – See Table 3 for
recommended TDM bus time slot allocations.
Typically, a console only requires one (1) slot;
however, allocating four (4) slots for each console
as shown in the table will ensure all CIM audio
channels are available when/if Call Director patch
equipment is interfaced to the respective console.
Table 3 – Recommended TDM Bus Time Slot
Configuration For Compact CEC
CEC
MANAGER
DESIGNATION
COMPACT CEC
INTERFACE
MODULE
SLOTS TO
ALLOCATE
"
Console 1
" CIM 1 4
"
Console 2
" CIM 2 4
"
Console 3
" CIM 3 4
"
Site 1
" (the
EDACS site)
MIM 1 12
"
Site 2
" (the
conventional
interface)
VMIM 1 8
RADIO SYSTEM "SITE"
CONFIGURATION
From the CEC Manager, set-up channel parameters for
the Compact CEC's "site"-type interfaces – the MIM for
"Site 1" and the VMIM for "Site 2". Refer to LBI-38938:
❏
Input And Output Line Levels – Adjust input and
output line levels for all used MIM and VMIM
channels. Note the CI Board used in the CIA rack
has unity gain channels; therefore, a VMIM's input
and output line levels should be set in accordance
with the line levels in to and out of the respective
CI Board's channels.
❏
Channel Control Signalling – Set all MIM
channels' control signalling as required – "
M
",
"
Tone
", "
Both
" or "
Off
". Set all VMIM
channels "
Off
".
❏
Confirmed Call – Disable confirmed call
operation on both the MIM "site" and the VMIM
"site".
NOTE
Within this manual, the Compact CEC's MIM is
designated as being interfaced with "Site 1" (Site
ID = 1) and the VMIM is designated as being
interfaced with "Site 2". This is not the case if the
respective Controller Board's site assignment
number DIP switch setting has been changed from
the factory setting. See the prior section entitled
"DIP SWITCH CONFIGURATION" for
additional details.
CONSOLE CONFIGURATION
From the CEC Manager, set-up the following
parameters for the C3 Maestro console(s):
❏
CIM Channels – Configure channel 1 of each
CIM by setting its input level as required and
disable the channel's ALC. Typically, a -5 dBm to
0 dBm input level setting should be sufficient for
the 100-foot (30.5 meters) console-to-Compact
CEC cables supplied with the C3 Advantage
package. If a particular console is equipped with
Call Director patch equipment also set channel
four's (4) input level as required and disable this
channel's ALC. All CIM output levels are
determined by the console's volume bars; they
cannot be changed via the CEC Manager. See
LBI-38938 for additional details.
❏
Console Hardware Configuration – Configure
console hardware related parameters such as the
number of speakers, the number of Audio PA
Boards and the Call Director ID number. See
LBI-38938 and/or LBI-39055/LBI-39101 for
additional details.
NOTE
The console(s) must be on-line with the Compact
CEC before continuing with the following console
user profile, privilege lists and communication
module build procedures.
❏
Console User Profiles – Configure, save and send
console user profiles as described in LBI-38938.
❏
Console Privilege Lists – If the System Manager is
employed, configure, save and send console
privilege lists as described in LBI-38938. Do not
perform this operation if the C3 Advantage
dispatch system is "System Manager-less".
NOTE
NOTE