Reference Manual Part 6
Table Of Contents
- FBTEST Reference Manual
- 1 Introduction
- 2 Installation Procedures
- 3 Hardware, Equipment and Preparation
- 4 FBTEST User Modes
- 5 User Interface Description
- 6 Main Menu
- 6.1 Board Test Menu
- 6.1.1 Alt. 1: Do the Test
- 6.1.2 Alt. 2: Number of Test Cycles
- 6.1.3 Alt. 3: Select/Unselect Boards
- 6.1.4 Alt. 4: Select Extended Test
- 6.1.5 Alt. 5: Select Medium Test
- 6.1.6 Alt. 6: Unselect all Tests
- 6.1.7 Alt. 7-11: Sets the Test Parameters for Each Board
- 6.1.8 Alt.7: Set Parameters for FCB–FE Computer Board
- 6.1.9 Alt. 8: Set Parameters for FRB–FE Radio Board
- 6.1.10 Alt. 9: Set Parameters for FNB–FE Connection Board
- 6.1.11 Alt. 10: Set Parameters for FMB–FE Modem Board
- 6.1.12 Alt. 11: Set Params for FPB–FE Power Supply Board
- 6.1.13 Alt.12: Look at Test Results
- 6.2 Set Time
- 6.3 Radio Operations
- 6.4 Measurement Setup Menu
- 6.4.1 Transceiver Control and Presentation Menu
- 6.4.2 Radio Calibration Menu
- 6.4.3 Bandgap Calibration
- 6.4.4 Temperature Sensor Calibration
- 6.4.5 Reference Oscillator OCXO Calibration
- 6.4.6 PF Output Power Calibration
- 6.4.7 PR Reflected Power Calibration
- 6.4.8 VCO Modulation Calibration
- 6.4.9 TCXO Modulation Calibration
- 6.4.10 RSSI Calibration
- 6.4.11 EEPROM Display Editor Menu
- 6.4.12 PA Bias and FDAC Calibration Menu
- 6.4.13 Radio Register Editor Menu
- 6.4.14 Adjustment
- 6.4.15 Setup
- 6.5 Modem Operation Menu
- 6.6 Status Overview Menu
- 6.7 Edit Loader Parameters Menu
- 6.1 Board Test Menu
- 7 Index
92 (102) BRU3 MANUAL
BRU3 MANUAL, Doc.no: 198 17-CAAA 808 288 Uen Rev H, 2003-06-06
6.7.2 Channels
Alt. 3 “Channels” in the Edit Loader Parameters Menu displays the following
menu:
[Main menu, Edit Loader Parameters, Channels]
If alternative 1 is selected, the “Choose alternative” will change to:
Channel number [1 - 5]: (1).
Figure 50 Define Channels menu.
Define channels SYS:yyyy-mm-dd hh:mm
Current test selection is MEDIUM
1. Channel : 1
2. Not in use
0. Previous menu
Choose alternative: _