Reference Manual

FBTEST REFERENCE MANUAL 99 (110)
BRU1/BRU3 MANUAL, Doc.no: b3fb_ref Uen Rev PJ5, 2004-02-19
[Main menu, Edit Loader Parameters, Ports, Modem Parameters, Init
Commands]
Note: Commands 1 – 5 above are used differently depending on the selected
control type. If ATHAYES is selected, commands 1 – 5 are sent to the
modem for initialization, followed by the telephone numbers specified
in Figure 57 “Edit Modem Parameters menu, Dial Commands.”. If
ATHAYES_LL is selected, commands 1 – 3 are sent to the modem to
initialize it for leased-line mode. If this does not work and the modem
attempts to established a dial-up connection, commands 4 – 5 are sent
to the modem for initialization, followed by the telephone numbers
specified in Figure 57.
Prior to an attempt to establish a connection, the loader program will send the
above defined init commands to the modem. It is possible to define additional
init commands in 4 and 5. For more information about modem settings, see
Node Hardware/BRU3/Telephone Modem Settings.
Alt. 8 DIAL COMMANDS
Displays the 10 Dial Command sequences, please refer to the menu
in Figure 57.
Figure 56 Edit Modem Parameters menu, Init Commands.
Modem Initial Command for Port 1 SYS:yyyy-mm-dd hh:mm
Current test selection is MEDIUM
1 Command 1 : ATE0
2 Command 2 : AT&D2
3 Command 3 : AT&M1
4 Command 4 :
5 Command 5 :
0. Previous menu
Choose alternative: _