Reference Manual

48 (110) BRU1/BRU3 MANUAL
BRU1/BRU3 MANUAL, Doc.no: b3fb_ref Uen Rev PJ5, 2004-02-19
Alt. 3 SAVE TEST DATA AT STOP
A toggle function between “ + “ (YES) and “ - “ (NO).
Measurement data is saved when the test period is finished.
Alt. 4 SET TEST TIME
Displays ENTER TEST_CYCLES (10)
The test period is set in cycles, which also correspond to time. A
sampling rate of about 1 second is selected, but can be changed to a
practical value if necessary.
Alt. 5 START The start command starts the measurement.
Alt. 6 LOOK AT PREVIOUS TEST DATA
Displays SELECT BUFFER 1 = LAST, 2 = PREV. or 3 = OLD (1)
Measurement data are stored in two buffers, i.e., the last and previous
results can be analysed. When this command is used, a question is put
to the operator as to which buffer to look at. These buffers are updated
if the save condition is activated.