Reference Manual

FBTEST REFERENCE MANUAL 45 (110)
BRU1/BRU3 MANUAL, Doc.no: b3fb_ref Uen Rev PJ5, 2004-02-19
6.4 Measurement Setup Menu
[Main menu, Radio Operations, Measurement Setup]
Figure 21 Transceiver Measurement/Test Setup Menu.
Alt. 1 - 8. A toggle function between “+” (select) and “-” (), is used to
select the type of measurements that should be performed. The
results of these measurements are shown in the presentation
menu.
Alt. 9 SELECT TRANSMITTER ON/OFF
A toggle function between “+” (ON) and “-” (OFF).
Transceiver Measurement/Test Setup Menu SYS:yyyy-mm-dd hh:mm
Current test selection is MEDIUM
1 -SELECT PF MEASUREMENT
2 -SELECT PR MEASUREMENT
3 -SELECT RSSI MEASUREMENT
4 -SELECT TEMPERATURE MEASUREMENT
5 -SELECT BIT ERROR RATE TEST
6 -SELECT LOOPBACK TEST
7 -SELECT ALARM STATUS
8 -SELECT DEVIATION MEASUREMENT
9 -SELECT TRANSMITTER ON/OFF
10 -SAVE TEST DATA AT STOP
11 SET TEST TIME: 0 IS FOREVERTEST CYCLES = 0
0. Radio Setup, Control and Calibration Menu
Choose alternative: _