Reference Manual

FBTEST REFERENCE MANUAL 33 (110)
BRU1/BRU3 MANUAL, Doc.no: b3fb_ref Uen Rev PJ5, 2004-02-19
6.1.14 Alt.12: Look at Test Results
When the batch tests are started, the Test Status is shown. It tells you how many
faults have been detected for each board, and how many test cycles have been
completed. If a 'Q' is pressed before the test is finished, the test is interrupted
after the current cycle, and the user has the option to select the alternative
“Continue the test” or stop the test by selecting the “0” alternative.
When the test is completed, either by itself or when the user has pressed 'Q', it
is possible to jump to the “Examine Board” screen for each board, by selecting
the appropriate alternative in the menu. Figure 16 “Example of “Examine
Board” screen.” shows an example of the Test Status menu when the test is
finished.
When selecting the “Look at test result” alternative (Alt. 12) in the Board test
menu, the selection between NEW, OLD and OLDEST test has to be made. The
three latest test results are stored and can be displayed.
SELECT RESULT BUFFER: (1) NEW (2) OLD
(3) OLDEST