Specifications

3
Tel. number programming
Before programming the mobile phone, you must do Master Reset
to assure the correct default
settings. Master Reset
is under the menu of Settings. In addition, it’s recommended to program the
tel. numbers and SMS message on the mobile phone independently, before connecting it to the GSM-
DL2.
The contact tel. numbers must be saved in the phone book (from #1 to #7) of the SIM card
(not phone memory) of the mobile phone, which connects to the GSM-DL2. For any numbers less
than 5 digits (including blank number), the GSM-DL2 will discard them.
Remarks:
1). In case no number is programmed in SIM card position #1 and #2, GSM-DL2
would delay 10~20 seconds to call #3 after it is triggered.
2). For the operation/setting of mobile phone, it varies with model number. You
have to refer to the operation manual of the mobile phone you use, or consult
your local Ericsson agent.
3). For T28, T29 and T65 mobile phones, if you feel complicate to set telephone
no. in SIM card position #1~#7, you may put the SIM card in another mobile
phone, with which you are familiar and can set the numbers on SIM card
position #1 ~#7 easily. After that, you take out the SIM card and put it in T28,
T29 or T65.
SMS programming
A). For A1018, S868 and T10 mobile phones
The SMS message to tel. #1 & #2
must be saved in the first
message of “To send
” list of the
mobile phone, which connects with the GSM-DL2. Refer to your mobile phone’s operation
manual, and erase all the SMS messages on the list of “
To send
” first, then key in new SMS
message you want (answer “NO” to the display of “Send Messages, Enter no:
”).
Note: Once the SMS message is sent after the GSM-DL2 is triggered, the message will not
remain on “To Send” list, instead it will show on “Sent” list of the GSM mobile phone.
Anyway, it doesn’t affect the SMS sending afterward.
B). For T28, T39 and T65
1. Select Messages
,
2. Select Templates
,
3. Delete all existed message if any,
4. Add new message, edit the text you want to send,
5. After finish, press Yes, then it displays “Send message now?”,
just press NO.
6. Press NO and NO again to return to main menu.
Note:
1). The lower cover of T10, T28 & T39 must be opened.
Otherwise, they cannot send SMS out!
2). The maximum length of SMS may vary with
mobile phone, please refer to the manual. Anyway, it’s
recommended to use shorter message (for example:
“Alarm from Bill’s car”.), since it’s easier to read.