Specifications

Integration Technical Note 17
NEC NEAX 2000/2400 MCI ©June 2003 Ericsson Enterprise AB
EN/LZT 108 6656 R1A
Configuring OneBox
Configuring OneBoxConfiguring OneBox
Configuring OneBox
Once the telephone system is programmed, you must configure OneBox for the
integration. During setup, you’ll need the following information, specific to this
integration, to configure OneBox.
1. In the Installation Configuration dialog box, enter the name of your site in
the Site Name box, the mailbox length in digits in the Mailbox Length box,
and the first extension number for the first line in the First Extension box.
Select NEC as the manufacturer, NEAX 2000 or NEAX 2400 as the model,
and MCI Serial Port as the integration type.
2. In the Switch Section Options dialog box, enter the hunt group access code
you configured previously in the section Programming the NEC NEAX 2000
IVS or Programming the NEC NEAX 2400 IMX. This is the pilot number
that users dial to reach OneBox.
3. In the Integration Options dialog box, verify the communication settings are
correct.
4. Once setup is complete, go to the Lines tab in the Configuration utility to
verify that the extension numbers are assigned to the correct lines, and enable
callouts to suit your application. For information on configuring callout
settings, see the topic “Configure callout settings,” in the online help system.
The settings related to the telephone system in the Switch Options dialog box are
filled in correctly when you select the correct telephone system during setup. You
may need to customize other settings in the Switch Sections and Integration
Options dialog boxes to suit the requirements of each application Refer to
Installing OneBox or the online help for more details about setting these
parameters. Or, to display a tooltip that briefly describes a setting, pause the
mouse over the setting for which you want more information.