Specifications
14 Integration Technical Note
©June 2003 Ericsson Enterprise AB NEC NEAX 2000/2400 MCI
EN/LZT 108 6656 R1A
Programming the NEC NEAX 2400 IMX
Programming the NEC NEAX 2400 IMXProgramming the NEC NEAX 2400 IMX
Programming the NEC NEAX 2400 IMX
Follow the recommendations and programming examples in this section to
program the NEAX 2400 IMX for integration with OneBox. Programming
examples show commands and parameters that are necessary for integration;
they do not represent PBX programming in its entirety.
The installing technician should be familiar with programming the telephone
system. For detailed programming information on the NEAX 2400 IMX
telephone system, refer to the appropriate NEC system command, data
specification, and feature manuals for the telephone system you are installing.
The programming examples in this section assume that you are programming the
NEAX 2400 IMX from a MAT terminal. Refer to the appropriate NEC manual
for specific information on hardware configuration, software commands, and
system data specifications.
Configuring the I/O port for the MCI Link
Locate an available I/O port on an existing I/O card or install a new card in an
appropriate slot in the PIM. Determine which port on the card will be used and
address the card accordingly. Configure the I/O port for a baud rate of 9600, 8-
bit word length, no parity, and 1 stop bit. No controls should be enabled.
Program the data format for the I/O port on the IO19 or IO24 cards with the
AIOC command. Follow the recommendations in Table 5 for switch settings on
the IO02 card. The switches you select are dependent on the I/O port you will
use as the MCI port.
Table 5. Switch settings for the PA-IO02-A card
Switch 01 (port 0) / Switch 11 (port 1)
1=OFF 2=ON 3=OFF 4=OFF 5=OFF 6=OFF 7=ON 8=ON
Value = 9600 baud, 8-bit word length, no parity, 1 stop bit
Switch 02 (port 0) / Switch 12 (port 1)
1=ON 2=ON 3=ON 4=0N 5=ON 6=ON 7=ON 8=OFF
No Controls Enabled