Specifications

Integration Technical Note 13
NEC NEAX 2000/2400 MCI ©June 2003 Ericsson Enterprise AB
EN/LZT 108 6656 R1A
Programming the Subscriber Stations
Program the subscriber stations for use with OneBox. Allow forwarding types
relevant to your application and enable Message Waiting/Message Reminder
capability for each subscriber. To prevent conflicts and confusion, only OneBox
should have the set and clear message-waiting capability. Disable message-waiting
set/clear capabilities on all subscriber stations.
1. Command Code CM15. Allow Call Forward-No Answer, Call Forward-Busy,
Call Forward-All, and MW reception for all OneBox subscribers in the
Service Restriction Class.
ST+15YY/YYY+DE+SERVICE RESTRICTION CLASS A/B/C
(00-15)+DE+DATA (1 digit)+EXE
2. Command Code CM13: Provide MW service to each subscriber station.
ST+1303+DE+STATION NUMBER+DE+0+EXE
3. Command Code CM90: Assign the data to provide the MW lamp on a
Dterm, if required.
ST+9000+DE+PRIMARY EXT NUMBER+DE+KEY
NO+F1005+EXE
4. Command Code CME6. Call Forwarding to OneBox for each subscriber
station can be set from the MAT terminal or from each subscriber station.
To set Call Forward Busy/No Answer at the MAT terminal use 03 as the
First Data with command E6.
ST+E603+DE+STN. NUMBER+DE+DEST (OneBox UCD pilot)+EXE
Completing the NEAX 2000 IVS Programming
Verify your work and that the programming is correct by listing or printing your
programming changes. Test the stations to be used for OneBox for ringing,
dialtone, and disconnect supervision. Verify that the MCI link can successfully
transmit and receive data packets with calls to the OneBox UCD group.