Specifications

10 Integration Technical Note
©June 2003 Ericsson Enterprise AB NEC NEAX 2000/2400 MCI
EN/LZT 108 6656 R1A
Table 3. CMD001: Assigning the Port 3 Attribute Data to the MCI port
First
Data
Description
Second
Data
Value
20 Baud 5 9600
21 Stop Bit 0 1
22 Data Length 1 8
23 Parity 0 None
80 Function 24 MCI
Programming the Analog VMS Ports for OneBox
Program extension numbers to the single-line ports that will be used as OneBox
voice ports. Choose an easily remembered number for the pilot number of the
UCD group that subscribers will dial for OneBox. Assign station numbers for
the remaining ports in consecutive ascending order. Use the commands listed
below to program and define the OneBox station ports. You must perform these
steps for each OneBox port.
1. Command Code CM10: Assign extension numbers to the line-circuit
interface ports to be used for OneBox. Refer to the NEC manual for slot
location and LEN number when installing the station card.
ST+10+DE+LEN+DE+STATION NUMBER+EXE
2. Command Code CM12: Assign the features for each OneBox station in
Station Class-1. A typical OneBox station will have DTMF enabled and an
unrestricted attribute in the Trunk Restriction Class. Program the ports in the
tenant group you will be using for OneBox and assign them to a Service
Restriction Class.
ST+1200+DE+STATION NUMBER+DE+3+EXE (DP/DTMF)
ST+1201+DE+STATION NUMBER+DE+11+EXE (Unrestricted)
ST+1202+DE+STATION NUMBER+DE+1515+EXE
(Assign Service Restriction Class A and B. Default=15)
ST+1203+DE+STATION NUMBER+DE+15+EXE
(Ordinary Telephone)
ST+1204+DE+STATION NUMBER+DE+01+EXE
(Tenant. Default=01)
ST+1205+DE+STATION NUMBER+DE+1+EXE
(No OneBox line appearances on any multi-line telephone)