Specifications

8 Integration Technical Note
©June 2003 Ericsson Enterprise AB NEC NEAX 2000/2400 MCI
EN/LZT 108 6656 R1A
Programming the NEC NEAX 2000 IVS
Programming the NEC NEAX 2000 IVSProgramming the NEC NEAX 2000 IVS
Programming the NEC NEAX 2000 IVS
Follow the recommendations and programming examples in this section to
program the NEAX 2000 IVS for integration with OneBox. Programming
examples show commands and parameters that are necessary for integration;
they do not represent PBX programming in its entirety.
The installing technician should be familiar with programming the telephone
system. For detailed programming information on the NEAX 2000 IVS
telephone system, refer to the appropriate NEC system command, data
specification, and feature manuals for the NEAX 2000 IVS you are installing.
The programming examples in this section assume that you are programming the
NEC 2000 IVS using the MOC command mode. If you are using the MAT
terminal to program the PBX, then use the associated MAT mode menu
command for each corresponding MOC command. Refer to the appropriate
NEC manual for specific information on hardware configuration, software
commands, and system data specifications.
Configuring the AP00 Card for the MCI Port
Initialize the PN-AP00 card
1. Initialize the PN-AP00 card and assign data to provide the MCI for OneBox.
Refer to the MCI System Manual, ND-45895 for complete details on
configuring the MCI. Configure the switches on the PN-AP00 as follows:
a. Set the Make Busy switch in the OFF (down) position to enable the card.
b. Set the Rotary Sense Switch to match the assigned slot location.
c. Set SW-0 DIPs 1, 2, and 3 to OFF and DIPs 4, 5, 6, 7, and 8 to ON.
d. Set SW-1 DIP 1 to ON and DIPs 2,3, and 4 to OFF.
2. Command Code CM05: Assign the card slot in software.
ST+05+DE+SENSE WHEEL (slot no.)+DE+04 (PN-AP00) +EXE
3. Command Code CMD101: Load initial data on the PN-AP00.
ST+D101+DE+0000+DE+CCC+EXE
4. On the PN-AP00 card, set the SW-1 DIPs 1,2, and 3 to ON and DIP 4 to
OFF. After changing SW-1, MP reset is required.