Specifications

6 Integration Technical Note
©June 2003 Ericsson Enterprise AB NEC NEAX 2000/2400 MCI
EN/LZT 108 6656 R1A
Installation Requirements
Installation RequirementsInstallation Requirements
Installation Requirements
Review the following information before performing any of the procedures in
this document. To successfully install this integration, you must meet the
installation requirements for the telephone system and for OneBox.
Telephone System Requirements
These are the requirements for the NEAX 2000 IVS telephone system:
• NEAX 2000 series 1600 or later
• NEAX Message Center Interface (MCI)
• An available serial I/O port on a PN-AP00 card with NEC cable NR559037-
107 for RS-232C connection between the MCI port and OneBox
• One analog port for each OneBox port to be configured
Use PN-4LCD-A cards, or their equivalent, because of their ability to
provide open loop-current disconnect signaling
These are the requirements for the NEAX 2400 IMX telephone system:
• One of the following PBX types:
→ NEAX 2400 UMG with release 4004 or later
→ NEAX 2400 MMG with release 4003 or later
→ NEAX 2400 IMG with release 5202 or later
→ NEAX 2400 SIM with release 5201 or later
NOTE
SIM and IMG RDS configurations do not support the MCI Feature 2
Application.
• The NEAX Message Center Interface (MCI) using the Feature 2 Application
mode of operation
• One available serial I/O port on a PA-IO02-A, PA-IO19, or PA-IO24 card
for the MCI port
Use the appropriate NEC RS-232C cable for the I/O port you will be
connecting to OneBox; NEC cables CA-1 or 68PH-S-2PORTS CA-A.