User guide

Contents
2/1553-FGC 101 1019 Uen A 2011-09-06
iii
Contents
Chapter 1: Introduction
Provides a description of the equipment, its main features and functions and
identifies the controls, indicators and connectors.
Chapter 2: Installing the Equipment
Provides installation requirements, preparation and installation procedures, details
external connectors and provides important safety information.
Chapter 3: Operating the EQ8096 Using the Web Browser
Details how to access and use the Web Browser Interface for a range of diagnostic
and other utilities.
Chapter 4: Alarms
Details the Alarm web pages and what is contained on them.
Chapter 5: Configuration of Conditional Access Using XML File Download
Details of how to configure service/component scrambling (static conditional access
event definition) when an external EIS ‘Event Information System’ is not available.
Chapter 6: Preventive Maintenance and Fault-Finding
Details routine maintenance tasks, servicing advice, fault-finding information,
warranty, maintenance and gives relevant disposal information.
Chapter 7: Code Upgrade and License Key Entry
Specifies the procedure for upgrading software via FTP and obtaining and entering
license keys to enable DVBCA functionality on the EQ8096.
Chapter 8: Unit Configuration via FTP
Details configuration storage to a local PC using the FTP get command and the
configuration of other units with the same parameters using the FTP put command.
Chapter 9: Upgrading EQ8096 with Input and Output Option Cards
Details the procedures for installing and removing Input and Out Option Cards
Chapter 10: EQ8096 M-CMTS System Test Specification
Describes the system test specification for on site test and verification of the
EQ8096 DEPI-MPT functionality using a CISCO uBR10K Core.
Annex A: Glossary
Annex B: Technical Specification