User guide

Introduction to the EQ8096
1.4 Guided Tour
1.4.1 Enclosure
The enclosure is 2U and is used as a stand-alone unit. All inputs and outputs are via
rear panel connectors, with the exception of the LCD and button input at the front of
the unit (for setting IP address).
1.4.2 Front Panel Description
The Front panel of the EQ8096 is fitted with a single power supply unit (PSU1) as
standard and may be optionally fitted with a second power supply (PSU2) to provide
1+1 redundancy. When two power supplies are fitted, they operate in load sharing
mode. Both are secured by clips and, if required, may be removed from the front of
the unit. On the left hand side of the panel is a 2-line LCD display which may be
used for local control configuration (see Chapter 2, Installing the Equipment for
details).
1.4.2.1 Front Panel LEDs
There are 7 LED indicators, 3 located on the left of the front panel and 4 located
across both power supplies, when fitted (see Figure 1.2 and Table 1.9).
Table 1.9 Front Panel Indicators
Indicator Color Description
Alarm Red This LED is lit when an alarm condition has been detected.
Power Green This LED is lit when power is being received.
Active
(DTI lock)
Blue
This LED is lit when the DTI client card is locked to the DTI
server (M-CMTS only).
PSU Power
x 2
Green This LED is lit when the power supply is in use
PSU Fault
x 2
Amber
This LED is lit when a fault condition is detected in the power
supply
2/1553-FGC 101 1019 Uen A
1-11