User guide

Unit Configuration via FTP
2/1553-FGC 101 1019 Uen A
8-4
1400 bytes received in 0.84 seconds <1.66 Kbytes/sec>
ftp>
Note: The unit will only accept one FTP session, so if there is no request for a
username and password a session is already open that needs to be closed
8.3 Configuring Units Using the Stored File
The file is written to the unit using the ftp put command to one of two file
destinations.
Note: The change to the unit configuration is automatically applied.
• Open an ftp session.
C:\\ftp 172.17.125.32 (unit IP address)
• From the ftp session
ftp> put
<local-file> EQ8096config.txt
<remote-file> config
The target filename config filters out the Control Port IP Address and Netmask so
that the connection is maintained.
Note: It is possible to reset the unit by using an ftp put of any file to the EQ8096
target file resetunit.