User guide

Installing and Powering Up
2.1 Introduction
2.1.1 General
This chapter provides configuration and connection information for planning the
installation of the MX8400 Multiplexer, or for installing the equipment at another
location. This information also enables the final set up of the equipment to be
checked in the event of a fault. In the event of problems, contact Ericsson Customer
Services (see Preliminary Pages).
2.1.2 Site Requirements
2.1.2.1 Power Supplies
The MX8400 Multiplexer can operate from the following power supply voltage range:
• 100 – 240 V AC, 50/60 Hz (80 W with NO options fitted).
See Annex B, Technical Specification for a full specification.
2.1.2.2 Environment
The MX8400 Multiplexer is intended to operate in ambient air temperature
conditions in the range 0°C to +50°C, and humidity 0% to 95% (non-condensing).
See Annex B, Technical Specification for a full specification. Do not install this
product in areas of high humidity or where there is danger of water entry.
2.1.2.3 Lightning Protection
Warning!
If the MX8400 Multiplexer has been subject to a lightning strike or power surge and
has stopped working, disconnect the power supply immediately. Do not reconnect
power until it has been checked for safety. if in doubt, contact Ericsson customer
services.
Where appropriate, ensure this product has an adequate level of lightning
protection. Alternatively, during a lightning storm or when it is left unattended and
unused for long periods of time, unplug it from the supply outlet and disconnect the
antenna or cable system. This will prevent damage to the product from lightning and
power line surges.
2/1553-FGC 101 1014 Uen B
2-5