User guide

BISS Support
A Conditional Access Table (CAT) is present in the multiplex for BISS Mode 1,
although the table is empty as no Entitlement Management Message (EMM) stream
is present.
J.3 Configuring BISS
This section describes how to setup BISS in nCompass Control.
J.3.1 BISS Capabilities
• Maximum number of scrambled components per output is 256.
• Maximum number of session words is 512.
J.3.2 Setting The Session Word
Use the steps in Table J.1 to set the Session Word.
Table J.1 Setting the Session Word
Step Action Result Comments
1
In nCompass Control, Profile
Manager, locate the required profile to
configure.
2
In the chosen profile locate the service
to set the session word on and right-
click.
Displays a pop up
menu as shown in
Figure 1.
2/1553-FGC 101 1014 Uen B
J-4