User guide

PSIG Support
Figure I.1 Static Parameters: PSIG Ports
I.3.2 Configuring PSIG
Click OK to the PSIG Port selection in the Static Parameters Editor (see Figure I.1)
to display the PSIG Ports Editor (see Figure I.2). Select up to 32 unique port
numbers.
Notes: Figure I.2 shows when an external PSI Generator is unused. (ie all port
values are set to 0).
The MX8400 requires a reboot after the PSIG static parameters are
changed. This information is also sent as a warning alarm to nCC.
The only user configuration is the Static Parameter setup, everything else is done
according to the ETSI specification by the PSIG.
2/1553-FGC 101 1014 Uen B
I-4