User guide

Conditional Access
D.7 Configuring nCC Profile Manager
D.7.1 Service/Component Level Entitlement Control Messages
D.7.1.1 Select the Service/Component ECM
Table D.7 describes the procedure for adding service-level and component-level
ECMs.
Table D.7 Adding Service/Component Level ECMs
Step Action Result Comments
1
In nCompass Control,
Equipment Setup, select the
required Physical Map.
ECM at service level: right click
the service and select Add ECM
2
ECM at component level: right
click the component and select
Add ECM
D.7.1.2 ECM Dialog Box: General Tab
Table D.7 Adding Service/Component Level ECMs (continued)
Step Action Result Comments
3
Click the General tab and enter a
label for the ECM
4
In the CA System ID list, click
the appropriate vendor ID
If there is more than one type of CA in use,
the CA System ID list shows the CA types
defined earlier
5
In the CA Type list, click the
appropriate CA type
6
Ensure the Disable CA
Descriptor in PMT check box is
not selected
If this is selected then the CA descriptor will
not appear in the outgoing PMT
2/1553-FGC 101 1014 Uen B
D-20