User guide

Conditional Access
Step Action Result Comments
If IP Address 1 is the master ECMG, set Main
IP to 0
4 Enter the Main IP
Can be set to
either 1 or 0
If IP Address 2 is the master ECMG, set Main
IP to 1
5 Enter the Filter Set to 0
6 Define the ECMG Port
Enter the TCP
port the mux
connects to
the ECMG
7
When completed, check that
no other ECMG connections
have been defined other than
the ones to be used
D.6.2 Upload the Map
After making all the necessary changes, upload the map.
Note: If any IP addresses are changed, the multiplexer needs rebooting after the
map is uploaded before the change will take effect.
After the map has been uploaded, check the Static Parameters have been correctly
applied:
• Read them in again from the physical map
D.6.3 Connecting the ECMG and EMMG using nCC
The ECMG and the EMMG are then connected to the mux via an Ethernet hub as
shown in Figure D.10.
After setting up the ECMG and EMMG, they are then connected to the Ethernet hub.
The Ethernet hub is then connected to the configured CA in the Multiplexer.
2/1553-FGC 101 1014 Uen B
D-18